Cisco
Question: 1
|
You have configured your Cisco TelePresence Codec C90 but discover unwanted noise during use. What best practice will help avoid this problem?
A. Connect only one device at a time to an input and avoid daisy-chaining.
B. Recycle the power on your system after adding each additional input.
C. If you are not using an input, turn it off.
D. Daisy-chain additional devices using a serial cable to provide separate power supplies.
Answer: C
|
Question: 2
|
Refer to the exhibit.
Which two letters represent input connections on the Cisco TelePresence Codec C90? (Choose two.)
A. A
B. B
C. C
D. D
Answer: A,D
|
Question: 3
|
You want to reconfigure the H.323 and SIP settings using the remote control on the Cisco TelePresence Codec C90. Which menu allows you to do this?
A. Audio input levels
B. IP settings
C. Advanced configuration
D. Protocol configuration
Answer: C
|
Question: 4
|
What do you need to do before an endpoint can place or receive H.323 calls using a URI address?
A. Register the endpoint to the SIP server.
B. Register the endpoints to the gatekeeper.
C. Register the endpoint to the gateway.
D. Register the endpoint to the Cisco TelePresence MCU.
Answer: B
|
Question: 5
|
Refer to the exhibit.
You are installing a high-definition (720p or 1080p) monitor on the Cisco TelePresence Codec C90. Which of the outputs that are represented by letters in the exhibit should you use?
A. A or B
B. A or D
C. A or E
D. B or C
E. D or E
Answer: D
|
Question: 6
|
While on a call, using the remote control, how do you add an additional participant to a call on your MultiSite-enabled endpoint?
A. Press the Home button to return to the menu, and select the Add Participant button.
B. Press and hold the End Call key to bring up the dialing menu.
C. Press and hold the Call key to bring up the dialing menu.
D. Press the Call key, and choose or dial the number of the additional participant.
Answer: D
|
No comments:
Post a Comment